Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 22.06.2025 02:16

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

Why do so many guys love anime girls?

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

2024–10–10[John johnson John Johnson ]

Are greedy private sector landlords responsible for Britain's housing crisis?

In schematic diagrams this is the symbol for a fuse:

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

Can being annoyed be a sign of getting angry?

Because the load is inductive, the current lags the voltage.(by a bit).

nine

[image of Common-mode choke]

This Common Herb May Hold the Key to Fighting Alzheimer’s, According to a New Study - Food & Wine

so, what happens?

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

The bolt then partially travels down the line to your home.

Measles case confirmed in eastern Iowa - KCRG

There are three different concepts here that are getting confused.

Upvotes:

Barnstars:

2-year-old boy is swept away on luggage conveyor belt at Newark Airport in latest terror at beleaguered travel hub - New York Post

One is “what exactly is in a ‘surge protector’ ? ”

But… the neutral is now “floating” because of the 1 ohm resistance.

What does a fuse do?

Is Russia now too weak to save the Assad dictatorship in Syria again?

Can the fuse protect the electronic devices from lightning instead of a surge protector.

It also is a device that limits the change in current flow.

At one ohm, the resistor has a maximum of 1 watt power.

Ok, so this is a question seeking an answer to clear up whatever gymnastics are in my head. I'm a moderately attractive guy, sincere heart, genuinely looking to love another, established. Why don't women that I'm attracted to, want me back?

I post the exact comment here.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

A common herb shows promise for boosting brain health and fighting Alzheimer’s - PsyPost

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

A fuse is a non-resetable over current circuit protector.

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

King Charles praised for 'faultless' firing technique at Larkhill - BBC

He then describes Rainy Season and Lightning.

The other is “what does a “fuse” do?”

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

Your Apple Watch Is Getting a Neat New Feature That You’ll Actually Use - Gear Patrol

but this device (an Inductor) … impedes the rapid changes in the current.

For this case there are devices called Metal oxide varistors (MOV).

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

Evidence piles up that Trump's tariffs are crushing job market - Daily Kos

2024–10–14 [Omar Gharbi Omar Gharbi ]

At least they know the answer if they wanted it.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

but I think this circuit , shows a few more pieces.

(Dc diagram shown, AC is similar).

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

This is 'the assistant's answer'

Edit 2024–10.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

He then describes the function of a fuse.

A circuit breaker is similar, but is resettable.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

It seems Mohan does not understand the difference between a comment and an Answer.

a photo is worth a thousand words.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

There are two important concepts here.

The MOV will conduct when the voltage exceeds 50% of line voltage.

These devices are installed between the “hot” and “neutral” and protective ground.

the problem then depends on "how fast does the fuse operate?".

This is the picture of an electronic coil of wire wound around a core of magnetic material.

eight

But it can get overloaded, and no longer works.

One

[old diagram got deleted by accident]

So, the voltage could go up to 500 volts, and the fuse will not open up.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

An AC voltage/ current source, and an ac inductive load.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Now when you have a certain ac resistance, then a current flows in a loop.

These are simplified answers to the original question, and does not change anything I wrote above.

He then asserts :

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

First Sentence:

This is where this question deviates from being a 'generic' question, and becomes more specific.

This is where the MOV conducts again, and dissipated the energy.

This one hit behind the barn.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

Here is a simplified AC power diagram.

This device then solves the entire problem.

The third is lightning and “how it gets conducted into a home.”

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

2024–10–16 [ OO OLAOYE OYEBODE ]

What is lightning?

what exactly is a ‘surge’ protector?

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi